Valtech Sensor Automatic Urinal Flusher
...Valtech Sensor Automatic Urinal Flusher
Wall Mounted, Chrome Body, Inner Brass
Fully Intergrated
Converts existing Button type
Flusher to Sensor
Power DC 6V, Uses 4 AAA
Alkaline batteries
Detection Zone: 20cm,
Water Pressure: 0.05 – 0.8 Mpa
Diameter of inlet pipe: G1/2”
Display method : 4-digit 7-segment LED
Control method : ON/OFF control, P, PI, PD, PID control
Input specification : Thermocouple: K(CA), J(IC), T(CC), R(PR), S(PR), L(IC)
RTD: DPt100Ω, Cu50Ω
Sampling cycle : 100ms
Control output : Relay(250VAC~ 3A) or SSR drive(12VDC ) [ON/OFF]
Power supply : 100-240VAC~ 50/60Hz
Approval :
Power supply: 110/220VAC 50/60HZ
Allowable voltage range: 90 to 110% of power supply
Power consumption: Max 3VA
Display method: 7 Segment(red) LED method
Character size (WxH): 7.2 X 9.8mm
Display accuracy: F.S ±0.5% rdg ±1digit
Setting type: Digital setting
Setting accuracy: F.S ±0.5%
Sensor input: Thermocouples: K(CA),J(IC),R(PR)/RTD:DPt100Ω
※There is no R(PR) in T3S,T3H Series.
Input line resistance: Thermocouples:Max 100Ω /RTD: Allowable line resistance max 5Ω per a wire
Control output: relay output: 250VAC 3A 1C
SSR output: 24VDC ±3V 20mA Max
Current output: DC4-20mA (load 600Ω Max)
Sensing type : Narrow beam reflective type
Sensing distance : 70 to 130mm
Sensing target : Opaque, Translucent material(min. sensing target: min. Ø0.2mm(copper wire))
Light source : Red LED(650nm)
Response time : Max. 1ms
Power supply : 12-24VDC ±10%(ripple P-P: max. 10%)
Operation mode : Light ON/Dark ON(set by switch)
Control output : NPN open collector
